![]() In this step, the remaining paneling was installed.Ī base panel was fitted along with a panel to the left of where the table saw would eventually be installed. Doing this would allow me to connect a dust extractor to my table saw. Installing the table saw against the back panel meant I needed to remove a segment from the panel to accommodate the table saw exhaust. This meant that when the table saw would be installed the bed of the saw would sit against the back panel while the front of the saw bed would line up with the outer edge of the workstation. The first of these panels would be the back panel (as shown above) that was installed at a depth equal to the length of the table saw bed. This was important as the base on top of which the table saw would stand was going to be fixed to these panels. The first step in adding my table saw to the workstation was to install paneling that would box in the area where the saw would be placed. ![]() The instructions that follow are intended to be considered along with the visual instruction provided by the above video. Note: Because not all table saws have the same dimensions, this post will focus more on how I went about installing my table saw without too much emphasis on the exact dimensions. The only real obstacle I would need to overcome in doing this was to install the saw so that the bed of the table saw lined up perfectly flush with the top of the workbench. It would also allow me to use the 1.6m(5.3ft) width of the bench to support any overhang when I needed to cut wider stock. Doing this would allow me to use the entire length of the 2.4m(7.8ft) bench as an outfeed table (minus the length of the table saw itself). I wanted to add my table saw on one of the narrow ends of the bench. The cornerstone of my shop is my ( Makita MLT 100) table saw so it only made sense that the table saw had to be the first tool that needed to be added to my All-In-One workstation. >GET COMPLETE PLAN<<< Table saw outfeed table With the skeleton of the bench sorted it was time to get my first piece of equipment installed so I could start using my workstation. One place to store and use all my power tools in an effort to optimize my very small workspace.Īfter weeks of planning, I jumped in and assembled a rolling frame with an MDF top that gets explained in Part 1 of this bench build series. Not too long ago I had an idea to build one woodworking workstation to accommodate all of my most used equipment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |